Cable Curl

First Of All Thanks For Landing This Article, If You Are Searching for How To Do Cable Curl Properly Then We Must Say You Are In The Right Place. So, Without Getting Into The Query Less Directly Jump On The Cable Curl

Exercise Details:

  1. Force: Pull
  2. Synergists: Brachialis, Brachioradialis
  3. Target muscle: Biceps Brachii
  4. Mechanics: Isolation

How To Do Cable Curl?

  1. Attach a bar to a low cable pulley.
  2. Grasp the bar using a shoulder-width supinated (underhand) grip.
  3. Stand approximately one foot away from the pulley and lean backward a little.
  4. Your elbows should be by your sides, your arms should be almost fully extended, and the cable should be pulled taut.
Cable Curl


  1. Keeping your body still.
  2. Exhale as you curl the bar towards your shoulders until your elbows are fully flexed.
  3. Once your elbows are fully flexed, allow them to move forward a little (shoulder flexion), just until your forearms are vertical.
  4. Hold for a count of three and squeeze your biceps.
  5. Inhale as you lower the bar to the starting position, with your elbows by your sides and arms almost fully extended.
  6. Repeat.

Some Tips:

  1. Keep your body still.
  2. Only your arms should move.
  3. A wavy bar may be easier on your wrists than a straight bar.
  4. You can also use a V-bar.
  5. With the barbell and dumbbell curls, the biceps brachii does not experience much tension at both the top and bottom of the repetition because the angle of gravitational pull is directly downwards (i.e. the force vector is vertical).
  6. With the cable curl, if you stand approximately one foot away from the pulley and lean backwards a little, as described above, tension will be delivered throughout most, if not all, of the range of motion.
  7. See also the lying cable curl.

How To Do Cable Curl Video:

Cable Curl
Share This:


Do Daily Workout

Hello Everyone, I am a fitness freak and the founder of "Do Daily Workout".


Leave a Reply

Your email address will not be published. Required fields are marked *

error: Content is protected !!